2400 Watt peak MaxCore PMA 48 AC 3-wire Wind Turbine Permanent Magnet Generator

Description

2400 Watt peak Max-Core PMA 48 AC 3-wire
We sell other models too:
24 VDC -
CLICK HERE -
https://www.ebay.com/itm/332636102443
12 VAC -
CLICK HERE -
https://www.ebay.com/itm/332636113910
24 VAC -
CLICK HERE -
https://www.ebay.com/itm/232751203763
G
Video will open in a new window
When all else fails try tricky camera angles to make
ours
look smaller by setting it on the far rear end of the table.
Also compare a 7 magnet rotor to a 14 magnet rotor.
"Honesty Matters"
Who would you rather buy from?
WATTAGE LEVELS to WIND SPEED
2400 Watts peak / 2285 RPM at peak load.
For battery charging be sure to buy one of our "battery regulators"
Designed to operate in an area with low/medium speed averages of 4.3 to 5.6 m/s and greater (Zone 3-4)
Provides 303 kWh per month (3640kWh year)  8.8 kWh per day in a 12.4 mph (5.6 m/s) average wind speed.
In a zone 7 area this turbine can make up to 200% more power or 17.6 kWh.
Wind Zones are defined by m/s
Wind Zone 1      0 – 4.4 m/s  (Wind not recommended, go solar in this wind zone)
Wind Zone 2    4.4 – 5.1 m/s
Wind Zone 3    5.1 – 5.6 m/s
Wind Zone 4    5.6 – 6.0 m/s
Wind Zone 5    6.0 – 6.4 m/s
Wind Zone 6    6.4 – 7.0 m/s
Wind Zone 7    7.0 – 9.4 m/s  (20-22 mph)
If you win this auction
you will get a -
MAX-CORE ROTOR +n50
EASY TURNING PMA
You will receive only the most modern magnet core with deep saturation slotted magnets providing deep reaching pole power into the stator coil for maximum amperage.
There are plenty of "Look-A-Like" PMA's on the market that cost less.
The reason why they cost less
is that they are utilizing an old fashioned
The modern type PLATE AND GROOVE rotor that we have developed is the most celebrated and also the most copied type which we pioneered.  The important part is that PLATE AND GROOVE makes power at MUCH LOWER RPM's than the older and traditional Clam type rotor designs that do not provide deep magnetic saturation of the Stator coil offering 600% more power in low RPM scenarios over Clam type designs
In small wind turbines this is VERY important to make your power in the LOWER RPM ranges.
Spend a little more and get a LOT more  BANG-FOR-YOUR-BUCK!!!  Money well spent!
From the beginning GM designed the Delco to run
WET and even tested them to operate
Under Water
!
Our Magnets are on an
angle
for easy turning
We make our own brand new
ROTOR POLE
SHOES
AND
STATOR CORES
!